A121A Genset Control Module, Used in the MagneTek Generators, later to become Elliott MagneTek Power Systems 780RD repairs can be made on

repairs can be made on new units and if there are any problems after purchase Online Power Products will determine the cause of a failure and will stand by any factory defects

this cap is used on the power pac engine but will fit other applications such as generators etc

The purpose of this relay was to carry the heavier electrical loads

Parts book describes it as "gear end or the fan end"

This starter is used in the the Fiat 1600 engine

A121A Genset Control Module, Used in the MagneTek Generators, later to become Elliott MagneTek Power Systems 780RD repairs can be made onA121A Generator control module This unit was commonly in the MagneTek gaseous and diesel generators, models for example RNS 630 and RDS 630 etc. This controller was also used in the Winco line, the T & J Manufacturing line, also known as POW'R GARD Generators and the Baldor Generator line. Please notice the terminal strips on the right and left hand sides, some models used plugs here instead of the terminal landing strips. If yours is different then